Double click problem how to fix faulty mouse button

Double clicks on mice can occur for some common reasons. Fortunately, this does not usually mean that you have a hardware problem with your mouse. In most cases the problem is software related and can be fixed with a few tweaks. Now, let’s see how we can fix the mouse double click issue.

No peripheral will last for years. The wear and tear we cause during use results in reduced performance and useful life.

Especially if you move longer and faster, the mouse switches are forced to move in less time between each click, which puts more stress on the mouse.

Long presses with mechanical mice do not experience premature wear, but we can suffer a terrible double click.

Having a mouse double click issue means that when you click any of the buttons it will register as a double click in the system, i.e. we press it once and two clicks are recorded, the second is unintentional by the user.

Such a situation on any computer is annoying and never acceptable. However, most of the time the problem is not hardware related but software related. Therefore, it is better to look at possible solutions to the problem before sending the mouse for warranty.

Dirt

Dirt problem is very common on mouse wheel and mouse buttons. Dirt, dust and hair stick to any surface and get into the mouse through the toughest and smallest gaps. Dirt can get stuck between the mouse spring and the button.

Solving this problem requires completely disassembling the mouse and cleaning it with isopropyl alcohol and cotton swabs by highlighting the parts mentioned above. An aerosol with compressed air will help when the mouse is open to remove dust from the most complex and inaccessible places. In any case, while cleaning, do not touch the sensor unless it is stained.

Interference in wireless connection

Mice with a wireless connection may experience interference in the connection. The solution to this is quite easy. If we are in a place with a lot of Wi-Fi networks, we will be surrounded by radio waves on all sides, and the radio frequency or Bluetooth of the mouse may be affected by another device.

The best solution is to wire it if possible and the mouse allows it, and check for a double click. If the problem goes away, as a solution we will need to eliminate as much interference from nearby devices as possible.

Software related problems

Most popular gaming mice have settings for click times, which changes the response time with each press. Software-induced double-click problems may occur on mice whose software allows this.

In this case, it will be sufficient to enter the mouse settings in the relevant software and set this value.

Also, the mouse settings part of Windows itself can cause the problem. Go to control panel > mouse > buttons tab and enter double click speed section. There may be a problem with this setting.

Hardware related problems

The mouse may be experiencing hardware problems, there may be situations where the buttons are not responding properly and need to be replaced.

In general, there are moments when the mouse stays still on the computer, even though we move the mouse. A sharp buzzing sound may be heard at this time. This is due to the capacitors responsible for the printed circuit and the board’s USB controller, which does not go directly to the CPU.

There may also be coils accompanying them, but there is no doubt that they interfere with the USB to which the mouse is connected, so the solution is to simply plug it into a USB 2.0 port.